GE RSDetection RS-S131-200-ER0000 User Manual page 88

RSDetection
User's Manual
Parameter Support
C2H No
COM3
C3B Yes
C3P Yes
C3H Yes
COM4
C4B Yes
C4P Yes
C4H Yes
Alarm Dial
ADN No
External Serial Display
XDP Yes
XDU Yes
March 2016
Page 74
restart the unit after this command is sent for the changes to
go into effect.
Sets or returns the RS=232 port baud rate. Valid values are:
300,600,1200,2400,9600,19200. User must restart the unit after
this command is sent for the changes to go into effect.
Parity for the RS-232 port. Valid values are: (E, O, N). User must
restart the unit after this command is sent for the changes to
go into effect.
Handshaking for the RS-232 port. Valid values are:
0 = No handshake, 1=RTS/CTS, > 1 delay in mSec. User must
restart the unit after this command is sent for the changes to
go into effect.
Sets or returns the RS=232 port baud rate. Valid values are:
300,600,1200,2400,9600,19200. User must restart the unit after
this command is sent for the changes to go into effect. Make
sure COM4 is available on the unit before sending this
command.
Parity for the RS-232 port. Valid values are: (E, O, N). User must
restart the unit after this command is sent for the changes to
go into effect. Make sure COM4 is available on the unit before
sending this command.
Handshaking for the RS-232 port. Valid values are:
0 = No handshake, 1=RTS/CTS, > 1 delay in mSec. User must
restart the unit after this command is sent for the changes to
go into effect. Make sure COM4 is available on the unit before
sending this command.
Set returns the serial port used by the display.
0 = No display, 1 = COM1, 2 – COM2, 4 = COM4.
External display units 0 = R/h, 1 = Sv/h.
Comments
S131-200-UM Rev A
g