GE RSDetection RS-S131-200-ER0000 User Manual page 87

g
Parameter Support
ZLD No
ZMD No
ZHD No
Electrometer Gain
RLN No
RMN No
RHN No
RLV No
RMV No
RHV No
General
UID Yes
HEU Yes
DTF Yes
WDE No
COM1
C1B Yes
C1P Yes
C1H Yes
COM2
C2B Yes
C2P Yes
Copyright © 2016 General Electric Company. All Rights Reserved
Returns 0.
Returns 0.
Returns 0.
Returns 0.
Returns 0.
Returns 0.
Returns 0.
Returns 0.
Returns 0.
Sets or returns the unit address 0-Z except '@'.
Sets or returns the R to Sv conversion factor..
Legacy date format 0 = mm/dd/yy, 1=dd/mm/yy.
Watchdog enable. Returns 1.
Sets or returns the RS=232 port baud rate. Valid values are:
300,600,1200,2400,9600,19200. User must restart the unit after
this command is sent for the changes to go into effect. Make
sure COM1 is available on the unit before sending this
command.
Parity for the RS-232 port. Valid values are: (E, O, N). User must
restart the unit after this command is sent for the changes to
go into effect. Make sure COM1 is available on the unit before
sending this command.
Handshaking for the RS-232 port. Valid values are:
0 = No handshake, 1=RTS/CTS, > 1 delay in mSec. User must
restart the unit after this command is sent for the changes to
go into effect. Make sure COM1 is available on the unit before
sending this command.
Sets or returns the RS=232 port baud rate. Valid values are:
300,600,1200,2400,9600,19200. User must restart the unit after
this command is sent for the changes to go into effect.
Parity for the RS-232 port. Valid values are: (E, O, N). User must
RSDetection
User's Manual
Comments
S131-200-UM Rev A
Page 73