Table 6 Events - GE RSDetection RS-S131-200-ER0000 User Manual

RSDetection
User's Manual
Events, descriptions, and states are shown in Table 6. Each event has one or more possible
states.
In the cases where more than one state is possible, an update to the event log and/or a
notification will be sent if the state changes, assuming the event were configured to do so.
For those events with only one state such as Date/Time Set, the log or notification is
written or activated whenever this action occurs, even though there is no change in state.
Event
Range
ElectrometerUpdate
Electrometer EepromStatus
Electrometer ConfigurationChange
HPICConfigurationChange
External Power
BatteryPresent
SystemStatus
DatabaseStatus
March 2016
Page 32

Table 6 Events

Event Description
Indicates the current
electrometer range.
This event is set
whenever a new dose
rate measurement is
available.
At startup and upon
command an EEPROM
test can be run and the
results are reported
with this event.
Set if any change to the
electrometer
configuration occurs.
Set if any change to the
HPIC configuration
occurs.
Detects the presence or
absence of external DC
power.
Indicates whether a
battery is installed or
not.
A global indication as
to whether alarms are
active.
Current database
status.
g
State
RangeLow
RangeHigh
ElectrometerUpdate
EEPROMIdle
EEPROMPass
EEPROMFail
EEPROMInvalidConfiguration
Only used for event logging and
will never change on this screen.
Only used for event logging and
will never change on this screen.
Power Off
Power On
BatteryPresent
BatteryNotPresent
SystemStatusNormal
SystemAlarm
DatabaseOK
DatabaseError
S131-200-UM Rev A