Table 7 Measurements - GE RSDetection RS-S131-200-ER0000 User Manual

g
Measurements, descriptions, and units are shown in the Table 7.
Measurement
DoseRate
DoseRateStdDevPercent
IntegratorTemperature
ElectromenterTemperature
ElectromenterHumidity
PowerCycleCount
MinutesTillFullCharge
MinutesTillEmpty
Battery Voltage
BatteryCurrent
BatteryTemperature
RemainingBatteryCapacity
FullChargeBatteryCapacity
PercentBatteryCapacity
Uptime
DaqTemperature
DaqHumidity
Copyright © 2016 General Electric Company. All Rights Reserved

Table 7 Measurements

Measurement Description
The gamma dose rate.
This is the standard deviation as a percent of
reading for the dose rate.
The measured temperature inside the shield cover
within the electrometer.
The temperature inside the electrometer can be
outside of the shield cover.
The humidity inside the shield cover within the
electrometer.
The number of charging cycles the battery has
experienced.
Number of minutes till full charge as determined by
the battery charger.
Number of minutes till the battery is empty as
determined by the battery charger.
Current voltage of the battery.
Current being supplied by the battery. Current being
supplied by the battery to power the unit is
indicated as a negative number while current going
into the battery during a charging cycle is positive.
Temperature of the battery.
Estimated capacity remaining in the battery.
Estimated full charge capacity of the battery.
Estimated full charge capacity as a percent of
design capacity.
The amount of time the unit has been running. If
power is cycled this number will return to zero.
Temperature measured on the DAQ board.
Humidity measured on the DAQ board.
RSDetection
User's Manual
Unit(s)
R/h (*)
Sv/h
Gy/h
%
°C (*)
°F
°C (*)
°F
RH
count
minutes
minutes
volts
amps
°C (*)
°F
Amp-hours
Amp-hours
%
Time Span
°C (*)
°F
RH
S131-200-UM Rev A
Page 37