Legacy Software Configuration; Legacy Command Support; D", "L" And "E" Commands; Table 22 "D", "L", And "E" Command Support - GE RSDetection RS-S131-200-ER0000 User Manual

g
RS-S131-200-DC-KIT
RS-S131-200-ELEC-K
RS-S131-200-G-KIT
RS-S131-200-S-KIT
RS-S131-200-CD
8.6 L S
EGACY OFTWARE
RSDetection supports a subset of the serial commands used on the older units. This section
describes the supported and unsupported commands.
THIS MODE OF OPERATION IS NOT RECOMMENDED FOR NEW SYSTEMS MADE
ENTIRELY OF RSDETECTION. IT SHOULD BE USED ONLY ON EXISTING SYSTEMS WHICH
INCLUDE BOTH RSDETECTION AND OLDER UNITS WHERE EXISTING CENTRAL
COLLECTION SOFTWARE IS ALREADY IN PLACE USING OLDER COMMANDS.
8.6.1

Legacy Command Support

Table 22 though Table 31 list commands from legacy units and specify those that are
supported and those that are not supported for the RSDetection firmware. Commands are
listed by category.
8.6.2

"D", "L" and "E" Commands

Command Support
D Yes
Copyright © 2016 General Electric Company. All Rights Reserved
Dust cover kit (includes covers for external connectors)
Electrometer assembly, with hardware
Gasket kit (includes case gasket and battery cover gasket)
Gasket kit, HPIC support
Manuals, Configuration Utility, Firmware
C
ONFIGURATION

Table 22 "D", "L", and "E" Command Support

Computes the average dose rate since the last "D" command
was received.
Command
#D0<CR>
Response
D Y 0 SSSS HHHH BB.BB AAAAA EEEE CC<CR><LF>
Y – Unit address
SSSS - CPU STATUS: 0 = OK 1 = ERROR,
A/D STATUS: 0 = OK 1 = ERROR
BATTERY STATUS: 0 = OK 1 = LOW (<6.0 V),
ALARM FLAG: 0 = NO ALARM 1 = ALARM.
HHHH – High voltage
BB.BB – Battery voltage
AAAAA – Dose rate in mR/h
EEEE – Minutes unit has been averaging
CC – Sum of digits not including the "D" or Check Sum
RSDetection
User's Manual
Comments
S131-200-UM Rev A
Page 69