Installation; Iia. Pre-Install Checklist; Iib. Alignment - Sears Kenmore 630.13902 Manual

INSTALLATION

Don't over tighten the 90° elbow. Doing so may damage the water inlet valve and
cause a water leak. Temperatures required for soldering and sweating will damage
the dishwasher's water inlet valve. If plumbing lines are to be soldered or sweated,
keep the heat source at least 6 inches (152.4 mm) away from the dishwasher's water
inlet valve.
Check local plumbing codes for approved plumbing procedures and accessories. All
plumbing should be done in accordance with national and local codes.
These instructions depict an installation method for stainless steel braided hose or
PEX hot water supply lines. If using copper tubing or other material for water supply,
defer to a licensed plumber for proper installation.
II. INSTALLATION
IIA. Pre-Install checklist
 Unpack unit.
packing material from inside the dishwasher.
 Inspect parts to ensure you have all the necessary materials.
 Flush household hot water supply for at least two minutes.
 Measure the enclosure area. The opening must be at least 34" (87 cm) high and 23-
5/8" (60-61 cm) wide.
 The opening must be close enough to the sink for water line and drain hose plumbing
access.
 Unit must be installed close enough to the sink so that drain hose length does not
exceed 92" (234 cm) and a high loop is raised at least 20" (51 cm) above the floor.
 Wooden openings must be sanded smooth and metal openings must be covered by
a protective gasket.
 Is your water heater set at 120°F (49°C) and does water pressure measure 15-145
psi (1-10 bar)?
 If installing in a corner, the dishwasher door must clear cabinet hardware.
 Determine mounting method based on dishwasher model and countertop type,
whether top or side mount.
IIB. Alignment
Carefully place dishwasher on its back to pre-adjust all three feet -- turn feet clockwise to
raise or counter-clockwise to lower. Maximum height with feet fully extended is 34.5".
Place dishwasher upright, then level side to side and front to back. When done, insert
leg leveler locking screw in back foot.
Regardless of countertop surface, mounting brackets are attached on the side of
dishwashers. They are screwed into screw bosses on the side dishwasher frame, then
into the cabinetry.
702_58300000150187_ara_en_a
Retain packing material until installation is successful. Remove