Sears Kenmore 630.13902 Manual page 42

Fault Diagnostics
Clearing fault (error) codes
To clear error codes, run the customer service test program.
Entering customer service test program
To enter customer service test program (from error code program "P0"), press
China Gentle button once. Digital display will show "P1". To start program,
press Fast Wash button. To skip a step, press China Gentle button – not all
steps can be skipped. To exit special programs, turn dishwasher off.
Special programs
Error codes* /
Customer service test*
Viewing customer service program
Customer Service Program
Displayed
step
Step Action
0 0 Check Coil
1 0 Drain Pump
2 1,2 Filling
3 3,4 Pause
4 5,6,10,11 Drain Pump
5 12,13,14 Filling + Main Pump
6 15 Main Pump + Soap
Dispenser
7 16 Main Pump + Aqua
Sensor Calibration
8 17 Main Pump + Heating
9 18 Pause
10 19 Main Pump
11 20 Main Pump + Rinse
A gent + Heating
12 21 Main Pump + Heating
13 22 Main Pump
14 24 Drain Pump
Hint: If a failure occurs the program goes on, stops or ends according to the failure handling.
Remark: Filling can not be stepped over
702_58300000150187_ara_en_a
Functional test+
Can advance
step
Time Temperature
no --
15s
partly 72s
yes 10s
yes 20s
no 96s
yes 10s
partly 110s
104°F
yes 5s
yes 5s
yes 60s
yes 149° F
yes 15s
no --
Digital
display
P0
P1
Water
amount Remarks
Checks pumps and other components
(when switched on)
Drain pump OK
3.0 L Checks if water level above filter level
Checks water level
empty Sump base completely empty
4.0 L Checks if water level at top of coarse filter -
main pump starts at displayed step 13
Start main pump
# of dispenser coil impulses = rinse agent
settin g
About 2.5°F/min
Displays "0" when done