Iiic - Sears Kenmore 630.13902 Manual

OPERATION
Changing basic features (on selected units)
Features can be changed on the fascia panel.
Entering settings mode
Door must be closed. Press the Power button to turn the dishwasher on.
The countdown display and one of the wash cycle lights will flash.
Press and hold the Normal Wash button, then press and release the
Start button. When the display shows "d:00 - d:01" (Dry Assist) or "r:00 -
r :06" (rinse-aid), release the Normal Wash button.
The display will show "d:00 - d:01" (Dry Assist) or "r:00 - r :06" (rinse-
aid) when you're in the change settings mode. If the display does not
show the option you wish to adjust, press the Normal Wash button to
select the other mode ("d" for Dry Assist or "r" for rinse-aid setting).
Dry Assist
With Dry Assist, the temperature of the rinse water can be raised and the
drying time increased for improved drying.
When the display shows "d:00" (Dry Assist off) or "d:01" (Dry Assist on),
turn the Dry Assist on or off by pressing the "+" or "-" button. Press the
Start button to save it.
Rinse-aid level
The amount of rinse-aid dispensed is changed on the control panel, not
at the dispenser.
When the display shows "r:00" to "r:06", change the amount of rinse-aid
dispensed from "r:00" (off)  "r:01" (lowest)  "r:02"  "r:03" (medium)
"r:04"  "r:05"  "r:06" (highest) by pressing the "+" or "-" button as
needed. Press the Start button to save it.

IIIC.

Entering special programs and coding
Controls can run customer service tests, show error codes, run sales demo
programs and run factory tests. The same procedure is used to access all
programs – don't run factory tests.
702_58300000150187_ara_en_a