Table of Contents
Advertisement
COMPONENTS
IV. COMPONENTS
IVA. Dishwasher components
Tank with base and sump
The tank, base and sump are assembled as one unit and aren't available as a
service part. If plastic cable holders, part holders and screw holes are damaged
or stripped, the entire dishwasher must be replaced.
Rear leveling foot
The rear leveling foot can't be adjusted from the front – the rear foot is the same
as front feet and is adjusted the same way. The base has provision for two rear
feet in the rear corners, but the center foot factory mounting should be used.
Factory feet positions have provisions for set screws (in installation parts bag).
Outside rear positions don't have set screw positions and shouldn't be used.
Right rear
adjusting foot
Heated circulation pump (heat pump)
There's no flow-through heater, flow switch or Hi-Limit cutout – the circulation
pump has a flow-through heated cylinder.
cylinder provides more heating surface area and heats water slightly more
quickly than traditional flow-through heating elements (~ 2ºF/minute).
circulation pump (portion) has a 3-pole BLDC motor controlled by the power
(control) module. The dishwasher won't run if the heat pump is disconnected or
disabled.
702_58300000150187_ara_en_a
Center rear
adjusting foot
Center rear foot set screw hole
The 120 VAC, 1200W heater
The
Advertisement
Table of Contents
