Installation Requirements - Sears Kenmore W10435038B Instruction Manual

INSTALLATION REQUIREMENTS
we
fools and Parts
Gather the recommended tools and parts before starting
installation. Read and follow the instructions provided with any
tools listed here.
All Installations
Tools needed:
Parts needed:
34"-Compr x %4" hose
Kit Number:-11000.
fitting. Contact your local
Sears Store to purchase
Pliers LE. LL Flat-blade
screwdriver
nut drivers or
hex sockets
Phillips SX Utility knife
screwdriver Za
Sie" and Ya" UL Listed/CSA
Approved twist-on
wire connectors*
Measuring tape
orruler
G)
Small level
10° adjustable w
that opens to
1%" (2.9 em)
rench
52" open-end
wrench
Torx®":T20° screwdriver
iP
*Must be the proper size to connect your household wiring
to 16-gauge wiring in dishwasher.
Other useful items you may need:
Flashlight >
Shallow
pan
GP
Parts supplied:
Drain hose: | Drain #10 x 4" 2- under- Under.-
clamps (2) -| hose Phillips-head | counter counter
(Varge and » |screws (2) | Mounting. [side mount
1-small) brackets (top) brackets
a,
c—3
Make sure all these parts are included in the literature package.
T®TORX and T20 are registered trademarks of Saturn Fasteners, Inc.
Other parts you may also need:
12"
(3.81-5 cm)
Screw-type
clamps (3: maximum)
Masking or
duct tape
NOTE: Parts available for purchase in plumbing supply stores.
Check local codes. Check existing electrical supply. See
"Electrical Requirements" section. It is recommended that
electrical connections be made by a licensed electrical installer.
In addition, for first-time installations
Tools needed:
Cordless. drill
with 14", 34"
and 1%" hole
saw bits
og
Small
tubing cutter
Wire-stripper
Parts needed:
Coppertubing ("
See "Electrical Requirements" section.
O.D. suggested) or
flexible braided
water supply line
For Direct Wire: | For Power Supply
use UL Listed/..-| Cord: use UL
CSA Approved] Listed/CSA
strain-relief Approved power
to.fit 4" (2.2.cm) | supply-cord kit
hole marked for use with
dishwasher