Welbilt FRYMASTER FilterQuick easyTouch Operation Manual page 80

Code
E44 RECOVERY FAULT
E45 RECOVERY FAULT – CALL SERVICE
E46 SYSTEM INTERFACE BOARD 1 MISSING - CALL
SERVICE
E51 DUPLICATE BOARD ID - CALL SERVICE
E52 USER INTERFACE CONTROLLER ERROR - CALL
SERVICE
E53 CAN BUS ERROR - CALL SERVICE
E54 USB ERROR
E55 SYSTEM INTERFACE BOARD 2 MISSING - CALL
SERVICE
E61 MISCONFIGURED ENERGY TYPE
E62 VAT NOT HEATING – CHECK ENERGY SOURCE –
XXXF OR XXXC
E63 RATE OF RISE
E64 FILTRATION INTERFACE BOARD FAILURE -
FILTRATION AND TOP OFF DISABLED - CALL
SERVICE
E65 CLEAN OIB SENSOR – XXX F OR XXX C - CALL
SERVICE
E66 DRAIN VALVE OPEN – XXXF OR XXXC
E67 SYSTEM INTERFACE BOARD NOT CONFIGURED
- CALL SERVICE
E68 OIB FUSE TRIPPED – CALL SERVICE
E69 RECIPES NOT AVAILABLE – CALL SERVICE
E70 OQS TEMP HIGH
E71 OQS TEMP LOW
ERROR MESSAGE
Recovery time exceeded maximum time
limit.
Recovery time exceeded maximum time
limit for two or more cycles. Call service.
SIB board 1 connection lost or board
failure. Call service.
Two or more controllers have the same
location ID. Call service.
The controller has an unknown error. Call
service.
Communications are lost between boards.
Call service.
USB connection lost during an update.
SIB board 2 connection lost or board
failure. Call service.
The fryer is configured for the incorrect
energy type. Call service.
The vat is not heating properly.
Rate of rise error occurred during a
recovery test. Ensure the oil level is at the
bottom oil level when cold and at the top
oil level line when at setpoint. On electric
fryers ensure the probe is not touching the
elements.
Filtration Interface Board connections lost
or board failure. Call service.
Gas -The oil is back sensor does not detect
oil. Clean optional oil sensor.
Drain valve is opened during cooking.
Controller is turned on when the SIB board
is not configured. Call service.
The VIB board OIB fuse has tripped and
didn't reset. Call service.
The controller has not been programmed
with product recipes. Replace controller
with factory programmed controller.
Oil temperature is too high for a valid OQS
reading. Filter at a temperature between
300ºF (149ºC) and 375ºF (191ºC).
Oil temperature is too low for a valid OQS
reading. Filter at a temperature between
300ºF (149ºC) and 375ºF (191ºC).
3-6
EXPLANATION