Welbilt FRYMASTER FilterQuick easyTouch Operation Manual page 25

DISPLAY
SETUP COMPLETE RESTART THE
SYSTEM
□ BRIGHTNESS
SETUP COMPLETE
□ SCREEN SAVER
SETUP COMPLETE
□ ALARM ATTRIBUTES
□ SHAKE ALARM MODE
SETUP COMPLETE RESTART THE
SYSTEM
□ HOLD ALARM MODE
SETUP COMPLETE RESTART THE
SYSTEM
71. Press the √ (check) button.
72. Press the Brightness button. This is used to set the
brightness of the screen. Use the up down arrows to
adjust. (Default is 100.)
73. Press the √ (check) button.
74. Press the smaller √ (check) button inside the SETUP
COMPLETE box.
75. Press the Down button.
76. Press the Screen Saver button. This is used to set the
amount of time, after the controller is turned off, before
going into a screen saver mode. Use the up down arrows
to adjust time. (Default is 15 minutes.)
77. Use the up down arrows to change the brightness of the
screen. Brightness has nine levels with 100 being the
brightest and 10 the darkest.
78. Press the √ (check) button when complete.
79. Press the smaller √ (check) button inside the SETUP
COMPLETE box.
80. Press the Alarm Attributes button
81. Press the Shake Alarm Mode button. Select Auto or
Manual. The Shake Alarm Mode allows the user to select
between auto or manual shake alarm cancel.
82. Press the √ (check) button.
83. Press the Hold Alarm Mode button. Select Auto or
Manual. The Hold Alarm Mode allows the user to select
between auto or manual hold alarm cancel.
84. Press the √ (check) button.
1-19
ACTION