Welbilt FRYMASTER FilterQuick easyTouch Operation Manual page 16

DISPLAY
□ ATO TYPE
AUTO PUSH BUTTON BOTH
SETUP COMPLETE
□ FILTRATION TIME SETTINGS
□ POLISH TIME
□ CLEAN TIME
□ AUTO FILTER FLUSH TIME
□ CLEAN & FILTER FLUSH TIME
□ OQS FILTER FLUSH TIME
□ OQS SETUP
□ OQS ENABLE/DISABLE
ENABLE DISABLE
SETUP COMPLETE
□ OIL TYPE
OC01v01, OC02v02, etc.
SETUP COMPLETE
□ DISPLAY TYPE
NUMBER TEXT
37. Press the ATO Type button.
38. Select AUTO if auto top if auto top off is installed. Select
PUSH BUTTON if only manual top off is installed. Select
BOTH if both auto and manual top off are installed and
desired.
39. Press the √ (check) button inside the SETUP COMPLETE
box.
40. Press the Filtration Time Settings button.
41. These settings should only be adjusted if instructed by
the factory.
The default settings are:
□ POLISH TIME -900
□ CLEAN TIME -3600
□ AUTO FILTER FLUSH TIME -45
□ CLEAN & FILTER FLUSH TIME -45
□ OQS FILTER FLUSH TIME -180
Press the back button when complete.
42. Press the Down arrow button.
43. Press the OQS Setup button if an OQS sensor is
installed.
44. Press OQS ENABLE/DISABLE button to enable/disable
the OQS sensor.
45. Select ENABLE to enable the OQS sensor or DISABLE to
disable the OQS sensor.
46. Press the √ (check) button inside the SETUP COMPLETE
box.
47. Press the Oil Type button.
48. Select the correct oil type curve. Press the down arrow
button to scroll to additional oil type curves. Use the
table on instruction sheet 8197316 to determine the oil
type. Ensure the oil type matches what the store is
using.
49. Press the √ (check) button inside the SETUP COMPLETE
box.
50. Press the Display Type button.
51. Select NUMBER or TEXT. NOTE: If set to NUMBER the
Total Polar Materials is shown as a number. If set to
Text, only DISCARD SOON/CONFIRM, OIL IS GOOD or
DISCARD NOW is shown.
1-10
ACTION