Welbilt FRYMASTER FilterQuick easyTouch Operation Manual page 20

DISPLAY
SETUP COMPLETE
CREW MODE
1.8 Fryer (Manager) Settings Programming
It is necessary upon initial power up or when changing out a controller to configure these local
manager settings for the fryer. The setup includes language, date and time, temperature scale,
sound settings, filter settings, energy savings, lane assignments and screen brightness. These
settings should ONLY be changed by a manager or technician.
DISPLAY
1 6 5 6
□ LANGUAGE
□ ENGLISH
□ SPANISH
99. Press the √ (check) button to save the value.
100. Press the √ (check) button.
101. Press the Home button.
102. Press the Crew Mode button.
103. Press and hold the momentary reset switch. Ensure the
switch is pressed and held for one (1) minute. In newer
fryers the switch is located below the USB port. On older
gas units, the button is located under the far-left control
box. On older electric units, the button is located on the
rear of the control box behind the JIB reset switch.
104. The system reboots in approximately 45 seconds and
returns to off/standby mode.
1. With the controller at the off/standby position, press the
Home button.
2. Press the Settings button.
3. Press the Manager button.
4. Enter 1656
5. Press the √ (check) button.
6. Press the Language button.
7. Press the Primary Language button.
8. Select the language desired.
9. Press the Secondary Language button.
10. Select the language desired.
1-14
ACTION
ACTION