Capture Memory - Johannus LiVE III AGO User Manual

Table of Contents

Advertisement

Manual Bass (MB):
Couples the Pedal monophonic to Manual II. Only the lowest key that is played on
Manual II is coupled from the Pedal to Manual II.
If only the lowest key of a chord is released, the pedal key activated by the
Manual Bass function is dropped until a new lowest key is played.
Activate the Manual Bass with the MB-piston.
It is advisable not to use the Manual Bass while playing the pedal board to avoid
double bass tones.
Cantus Firmus (CF):
Cantus firmus: Latin for 'fixed voice' or in organs 'solo voice' or 'melody coupler'.
Couples Manual III monophonic to Manual II. Only the highest key that is played
on Manual II is coupled from Manual III to Manual II.
With use of a solo registration on Manual III in this way a solo is heard while
playing only on Manual II.
If only the highest key of a chord is released, the key activated by the Cantus
Firmus function is dropped until a new highest key is played.
Activate the Cantus Firmus with the CF-piston.
It is advisable not to use the Cantus Firmus in combination with the coupler III-II
because this overrules the solo function of the Cantus Firmus.
Transposer (TRANS.):
The Transposer function shifts the pitch by half-tone
increments (from -8 to +8). The transposer setting can
be read on the display (Trans: ...).
1.
Press the TRANS.-piston.
2.
Use the - and + pistons to set the pitch.
3.
When the transposer change needs to be saved,
press the ENTER-piston in the time the TRANS. piston is lit.
Cancel function (0):
Pressing the 0-piston cancels all registrations.

Capture memory

Through use of the capture memory, a registration can
be activated with just one piston. The capture memory
consists of 50 levels (for ORGAN 1 – 5 = 250 levels).
These levels can be seen on the display (Mem:...). Each
level has eight memory locations (pistons 1-8). The
capture memory locations are not pre-programmed
and can be programmed by the user. The capture
memory has (50 levels times 8 pistons locations, equals) 400 locations per sample
set. Thus, the total amount of free programmable capture memory places in the
LiVE III AGO is (400 locations times 5 Sample banks, equals) 2000.
User Manual LiVE III AGO
Utrecht, Bätz
Location Organ Console
───────────────────────────
Mem
: 1
Trans : -1
Tune : 406,8Hz
Temp : Original
Cresc : Off
I/II/Pd
Utrecht, Bätz
Location Organ Console
───────────────────────────
Mem
: 1
Trans : -1
Tune : 406,8Hz
Temp : Original
Cresc : Off
II
III
23

Advertisement

Table of Contents
loading

Table of Contents