Capture Memory; Pre-Programmed Memory Locations; Capture Memory Locations - Johannus American Classic 770 User Manual

4.8

Capture memory

4.8.1

Pre-programmed memory locations

Pre-programmed memory locations are available by operating pistons T1 and T2.
These two memory locations have factory settings appropriate for the loud Tutti.
Calling up a pre-programmed memory location:
Press a pre-programmed memory location (T1 or T2). The active stops light up.
Programming a pre-programmed memory location:
The current setting of the pre-programmed memory location will be lost.
Although it is possible to store any registration under a piston of a pre-
programmed memory location it is advisable to select a registration matching the
text of the piston.
1. Select the desired stops.
2. Press the SET piston. Hold the piston.
3. Press the desired pre-programmed memory location (T1 or T2).
4. Release the SET piston.
4.8.2

Capture memory locations

Through use of the capture memory, a registration can be activated with just one
piston. The capture memory consists of 250 levels.
These levels can be seen on the display (Mem:...). The American Classic 770 has
eight general memory locations (general pistons 1-8) and six separate memory
locations per divisional (divisional pistons 1-6) per level.
Programming a capture memory location:
The current setting of the capture memory location will be lost.
1. Select the desired stops.
2. Use the - and + pistons to select a level (1-250) on the display.
3. Press the SET piston. Hold in the piston.
4. Press the desired memory location.
5. Release the SET piston.
Calling up a capture memory location:
1. Use the - and + pistons to select the desired level (1-250) on the display.
2. Press the desired memory location. The active stops light up.
User Manual American Classic 770 13