4.10 Capture memory
Through use of the capture memory, a registration can be activated with just one
piston. The capture memory consists of 75 levels.
These levels can be seen on the display (Mem:...).
Each level has eight memory locations (pistons 1-8).
The 600 capture memory locations are not pre-
programmed and can be programmed by the
musician.
Programming a capture memory location:
The current setting of the capture memory location will be lost.
1.
Select the desired stops.
2.
Use the - and + pistons to select a level (1-75) on the display.
3.
Press the SET piston. Hold the piston.
4.
Press the desired memory location (1-8).
5.
Release the SET piston.
Calling up a capture memory location:
1.
Use the - and + pistons to select the desired level (1-75) on the display.
2.
Press the desired memory location (1-8). The active stops light up.
Through use of the SEQ- and SEQ+ pistons previous or next memory locations can
be selected in steps of one. The lighted memory location piston and the memory
level shown in the display indicate the selected location.
4.11 Crescendo pedal
The crescendo pedal can be used to activate 20 registrations step-by-step. These
registrations start with very quiet (pianissimo) to very loud (tutti).
The default registrations of the 20 steps can be changed. See § 5.2 Crescendo.
Activating the crescendo pedal
If the crescendo pedal is not activated it is indicated
on the displays with Cresc:Off.
Use the CR piston to activate the crescendo pedal.
The display indicates the actual step.
User Manual Symphonica 450
16