Table of Contents
Advertisement
Although it is possible to store any registration under a piston of a pre-
programmed memory location it is advisable to select a registration matching the
text of the piston.
1.
Select the desired stops.
2.
Press the SET piston. Hold in the piston.
3.
Press the desired pre-programmed memory location (PP-T or PL).
4.
Release the SET piston.
4.10 Capture memory:
The memory feature enables a registration to be
activated easily with a single piston. The memory has
125 levels, which you can view on the display
(M1...M125). Each level has six memory locations
(pistons 1-6). The musician can use all 750 memory locations (125 levels times six
locations) for all organ styles. These locations are not pre-programmed and can
store registrations.
Programming a capture memory location:
The current setting of the capture memory location will be lost.
1.
Use the - and + pistons to select a memory level 1 – 6 for levels M1-M125 on
the display.
To change memory locations (M1-M125), instead of sequential steps (1-6) also,
hold down the SET piston and simultaneously press the + or - piston. Pressing the
combination of pistons for a longer time will increase the speed.
2.
Select the desired stops.
3.
Press the SET piston. Hold in the piston.
4.
Press the desired memory location (one of the pistons 1-6).
5.
Release the SET piston.
Calling up a capture memory location:
1.
Hold down the SET-piston and use the - and + pistons, to select the desired
level (M1-M125) on the display.
2.
Press the desired memory location (one of the pistons 1-6),
or press the – or + pistons. The active stops light up.
4.11 Transposer
The Transposer function shifts the pitch by half-tone increments (from -8 to +8).
The transposer setting can be read on the display
(Tr: ...).
1.
Press the TRANS piston.
2.
Use the - and + pistons to set the pitch.
User Manual Studio 260 / 360 / P-360
Rom. Front
85
Tr: 0/440
M
1
Rom. Front
85
Tr: 0/440
M
1
27
Advertisement
Table of Contents
