Capture Memory - Johannus LiVE 2T-A User Manual

Changing the pitch automatically changes the frequency.
Cancel function (CAN):
The CAN-piston is a function that turns all stops off by a single piston.
Plenum (PL):
Plenum registration function, consisting of (16',) 8', 4', (2 2/3'), (1 3/5',
Mixture(s)).
Keyboard Transfer (KT):
Keyboard Transfer (KT) is a function on the LiVE 3T-A only. This reversible function
exchanges the placement position of manuals I and II.
4.8

Capture memory

Through use of the capture memory, a registration can
be activated with just one piston. The capture memory
consists of 50 levels.
These levels can be seen on the display (Mem:...). Each
level has eight memory locations (pistons 1-8). The
capture memory locations are not pre-programmed
and can be programmed by the user. The capture
memory has (50 levels times 8 pistons locations, equals) 400 locations per sample
set. Thus, the total amount of free programmable capture memory places in the
LiVE 2T-A/3T-A is (400 locations times 5 Sample banks, equals) 2000.
Programming a capture memory location:
The current setting of the capture memory location will be lost.
1. Select the desired stops (for a selected Sample bank: ORGAN 1 - 5).
2. Use the - and + pistons to select the desired capture memory level (1-50) on
the display.
3. Press the SET-piston. Hold down this piston (to enable the storage function).
4. Press the desired memory location (1-8).
5. Release the SET-piston.
Calling up a capture memory location:
1. Use the - and + pistons to select the desired capture memory level (1-50) on
the display.
2. Press the desired memory location (1-8).
By holding down the - and + pistons for longer, the capture memory steps (1-50)
can be scrolled more quickly.
User Manual LiVE 2T-A / LiVE 3T-A (AGO)
Utrecht, Bätz
Location Organ Console
───────────────────────────
Mem : 1 █
Trans : -1 █
Tune : 406,8Hz █
Temp : Original █
Cresc : Off II
25