Safe SC 510 User Manual page 9

8
Use the table below to decide whether you need to use Lower Spacers (H1 & H2) between the
FastMount™ Rail and the wall. If you do need to use Lower Spacers, fit them between the Rail and
the wall so that the Screws (I-L) pass through and hold them in place.
Bottom of
Hinge Rail
Bottom of
Locking Rail
9
Fitting inside an opening
With skirting board or
wall sloping towards
No skirting board
opening
No Spacers required Small Lower Spacer
(H1)
(If skirting is more than
14 cm high, no Spacer
required)
No Spacers required Small Lower Spacer
(H1)
(If skirting is more
than 14 cm high, no
Spacer required)
UK
Fitting outside an opening
No skirting board
No Spacers required
Large Lower Spacer
(H2)
Choose the correct size Screws. Pass a Screw
through the lower hole in the Rail and any
Lower Spacer(s) required.
If fitting to wood
The Screw will need to protrude by 15 mm.
If fitting to plaster-covered brick or concrete
The Screw will need to protrude by 35 mm.
Smaller screws will be needed where no spa-
cers are used, larger ones as spacers are added.
The smaller fully serrated screw in each bag is
for use in the top of the Locking Rail.
With skirting board or
wall sloping towards
opening
Small Lower Spacer
(H1)
(If skirting is more than
14 cm high, no Spacer
required)
Small and Large
Lower Spacer
(H1 & H2)
9