Safe SC 510 User Manual page 12

16
Use both Allen Keys (S) to loosen (but not
completely dismantle) the 4 clamps, until the
2 panels can slide against one another. Do
not loosen the bolts holding the Secure-
Track™ in place.
18
Lift the handle and drop the 2 locator pins on
the locking side of the Gate Panel into the
Locking Rail. The handle should lock down
into place (as it locks, the window in the
handle will change from red to green).
20
If necessary, make ne adjustments by
loosening the 2 bolts at each corner of the
Gate Panel with the Allen Keys. Slide the panel
slightly back and forth until the Locator Pins
sit comfortably, then tighten the bolts back up.
12
UK
17
Slide the Gate Panels in or out so that the
Gate fits within the opening.
19
Slide the Gate left or right so that the Gate
fits symmetrically and correctly within the
opening before retightening the 4 corner
bolts. The Gate is correctly adjusted when
you cannot quite see the small red stripe
when looking down onto the handle with the
Gate locked and both pins fit comfortably into
the Locking Rail. You may also need to adjust
the corner bolts, see step 20.
21
Check that the Gate opens and closes smoo-
thly. If it is difficult to open and close, make
the Gate slightly narrower by adjusting the 4
corner bolts. If you can see the red line make it
slightly wider.