Safe SC 510 User Manual page 11

Fitting inside an opening
No skirting board
Hinge & Locking Rail -
No Spacers required on
either
14
If using a Spacer Block, check that the chosen
Screws are the correct length (Step 9), then
tighten the 2 Screws on each Rail. Reassem-
ble the Top Lock, positioning the ring of the
Magnet Lock so that it points directly towards
the Hinge Rail. Replace the top cap and screw
it all back together.
With skirting board
or wall sloping
towards opening
Hinge & Locking Rail -
Inner Spacer (M), Small
Outer Spacer Cover (N1),
plus appropriate Spacer
Inserts (O-Q)
UK
Fitting outside an opening
No skirting board
Hinge Rail -
No Spacers required
Locking Rail -
Inner Spacer (M), Small
Outer Spacer Cover (N1)
& appropriate Spacer
Inserts (O-Q)
15
Line up the Gate Panel (R) so that the 2 locator
pins line up and slide into the 2 hinges on the
Hinge Rail. Pull up to check that they have
clicked firmly into position.
With skirting board
or wall sloping
towards opening
Hinge Rail -
Inner Spacer (M), Small
Outer Spacer Cover (N1)
plus appropriate Spacer
Inserts (O-Q)
Locking Rail -
Inner Spacer (M), Large
Outer Spacer Cover (N2)
plus appropriate Spacer
Inserts (O-Q)
11