Multi-Feed Soap Tank Assembly Mounting - Bradley Verge Crestt Series Installation And Maintenance Manual

Verge Multi-Feed Soap Tank
®
4

Multi-Feed Soap Tank Assembly Mounting

Before mounting the soap tank assembly,
drill a 2-3/8" diameter hole through the deck
that is positioned 2-3/8" from the adjacent
back wall. This will ensure proper clearance
of the soap tank.
Remove the Fill Port Hub Assembly
A
Carefully disconnect the soap sensors and the
LED connector.
B
Remove the four thumb screws at the bottom of
the soap tank mounting brackets, and slide the
lower soap tank bracket forward.
C
Slide the soap tank downward from the bracket
assembly to remove the soap tank from the
mounting bracket.
8
Low Soap Sensor
Lower Soap
Tank Bracket
2/12/2020
2-3/8" Dia.
Mounting Hole
Thumb
Screws
Soap
Tank
Lower Soap
Tank Bracket
Bradley • P20-225 Rev. A: ECO 19-15-015A
Installation
LED Connector
(White)
Power Supply
Connection
Soap Overflow
Sensor (Black)
Low Soap Level
Sensor (Red)
Soap Supply Valve
Thumb
Screws
Soap Tank
Mounting
Bracket