Soap Spout Mounting - Bradley Verge Crestt Series Installation And Maintenance Manual

Installation
1

Soap Spout Mounting

A
Place the silicone washer under the soap
spout assembly. Align with the emboss
on the bottom side of the shank.
LED indication shows through
the silicone washer.
C
Insert the soap spout shank through the
mounting hole.
Verify there 2-1/8" diameter
clearance under the side of
deck for the locking tab.
Verify the soap spout shank &
silicone washer sit flat on the deck.
D
Position the locking tab key in line with
the keyway on the shank.
E
Feed the soap supply & vent tubes, and
LED & sensor wires through the opening
in the locking tab.
F
Thread the wing nut onto the shank.
Torque to 24 in/lb.
Bradley • P20-224 Rev. A: ECO 19-15-015A
Soap Spout
Assembly
1-3/8" Dia.
Mounting Hole
LED Location
Deck
Locking Tab
Soap Supply
Wing Nut
Key Way
Verge Deck-Mounted Soap Dispensers
®
Carefully insert the soap
B
supply & vent tubes, and the
LED & sensor wires through
the mounting hole.
Locking Tab
Wing Nut
Vent Tube, LED &
Sensor Wires
2/10/2020 5