Bradley Verge Crestt Series Installation And Maintenance Manual page 14

Verge Multi-Feed Soap Tank
®
Mid Tank Configuration Installation
See page 15 for an overview of the mid tank
configuration installation.
A
Cut one 1-3/4" piece of the 3/8" diameter tubing
and attach as shown.
Tubing will slide 3/4" into the fittings.
Connect the soap supply tubes between the
B
control boxes, cutting the supply tube to the
shortest length distance between units. See
illustration on page 15.
Cut one piece of tubing 3"–4" in length and
C
place the tubing through the straps on both
sides of the control box as shown. Repeat this
step for both ends of the soap supply system.
D
Install extra tubing after the shut off valve
(located at both ends of the soap supply
system).
Install the soap supply valve in the proper
flow direction as shown on the valve.
Use the extra tubing when cleaning and/or
maintaining the soap system.
14 2/12/2020
IN
OUT
Bradley • P20-225 Rev. A: ECO 19-15-015A
Installation
Soap supply valve is
shown in the open
position.
Soap supply valve is
shown in the open
position.
Soap supply
valve is shown
in the closed
position.