Bradley Verge Crestt Series Installation And Maintenance Manual page 10

Verge Multi-Feed Soap Tank
®
Install Fill Port Hub Assembly on Lav Deck
A
Install the fill port assembly through the 2-3/8"
diameter hole in the lav deck.
B
Place the stepped edge of the washer parallel
with the hemmed side of the mounting bracket.
C
Position the mounting bracket with the stepped
washer over the threaded portion of the fill port
hub assembly (located below the deck).
D
Thread the mounting nut onto the fill port hub
assembly. Hand-tighten or torque to 24 in-lb.
The distance between the soap dispenser
and the fill port hub assembly can only be a
maximum of 42" center to center.
Lav deck can only be a maximum of 1-1/2"
thick.
Install Soap Tank onto Fill Port Hub Assembly
Install the soap tank onto the center of the fill
A
port hub assembly until the bottom of the soap
tank is flush with the returned edged of the
mounting bracket.
CAUTION Keep the LED wire positioned to the
side of the fill port hub assembly when
inserting the soap tank to prevent the
LED wire from getting pinched.
B
Reposition the lower soap tank bracket into the
mounting bracket. Be sure to align the thumb
screw holes.
C
Insert the four thumb screws into the mounting
bracket to hold the soap tank assembly in
place.
10 2/12/2020
Fill Port Hub
Assembly
Stepped Side
of Washer
Mounting
Nut
Mounting
Bracket
Lower Soap
Tank Bracket
Bradley • P20-225 Rev. A: ECO 19-15-015A
Installation
Stepped
Washer
Hemmed Side of
Mounting Bracket
Low Soap
Level Sensor
Soap
Tank
Thumb
Screws