Verge
Multi-Feed Soap Tank
®
5
Soap Supply Connections
End Tank Configuration Installation
See page 13 for an overview of the mid tank
configuration installation.
Insert 3/8" diameter tubing into the soap supply
A
valve as shown. Connect the supply tube to the
nearest control box, cutting the supply tube to
the shortest length between units.
Tubing will slide 3/4" into the fittings.
Connect the soap supply tubes between the
B
control boxes, cutting the supply tube to the
shortest length between units. See illustration
on page 13.
C
Cut one piece of tubing 3"–4" in length and
assemble as shown.
D
Install extra tubing after the shut off valve
(located at the end of the soap supply system).
Install the soap supply valve in the proper
flow direction as shown on the valve.
Use the extra tubing when cleaning and/or
maintaining the soap system.
12
2/12/2020
IN
OUT
Bradley • P20-225 Rev. A: ECO 19-15-015A
Installation
Soap supply valve is
shown in the open
position.
Soap supply valve is
shown in the open
position.
Soap supply
valve is shown
in the closed
position.