Installation
1
Soap Spout Mounting
Repeat this procedure for each soap spout assembly (maximum of 6 per system).
A
Place the silicone washer under the soap
spout assembly. Align with the emboss
on the bottom side of the shank.
C
Insert the soap spout shank through the
mounting hole.
Verify there is 2-1/8" diameter
clearance under the side of the
deck for the locking tab.
Verify the soap spout shank &
silicone washer sit flat on the deck.
D
Position the locking tab key in line with
the keyway on the shank.
E
Feed the soap supply and LED & sensor
wires through the opening in the locking
tab.
F
Thread the wing nut onto the shank.
Torque to 24 in/lb.
Bradley • P20-225 Rev. A: ECO 19-15-015A
1-3/8" Dia.
Mounting Hole
LED Location
Deck
Locking Tab
Soap Supply
Wing Nut
Verge
Soap Spout
Assembly
Carefully insert the soap
B
supply & vent tubes, and the
LED & sensor wires through
the mounting hole.
Locking Tab
Wing Nut
Key Way
2/12/2020
Multi-Feed Soap Tank
®
LED & Sensor
Wires
5