Soap Pump & Vent Tube Connections; Power Source Connection - Bradley Verge Crestt Series Installation And Maintenance Manual

Verge Deck-Mounted Soap Dispensers
®
5
Soap Pump & Vent Tube Connection
The larger diameter tube is for the soap
supply and the smaller diameter tube is
the soap vent tube.
Attach the soap supply tube from
A
the spout assembly to the top of the
soap pump by pressing tube over the
hose barb fitting.
B Verify the soap supply tube is not
kinked and then position hand on the
control box and adjust the soap supply
tube or the soap pump as shown.
D
6

Power Source Connection

Each individual soap dispenser requires
the same connections.
The power source is located on the right
hand side of the control box.
The power supply can be a Bradley
supplied battery pack, a single AC
adaptor, or an AC adapter splitter
assembly kit, depending on the selection
made at time of purchase.
Connect the power supply to the power
A
source. When the connection is made, the
LED at the base of the soap dispenser
spout will flash green for 0.5 seconds.
8
Tube from Soap
Spout Assembly
Position the shoulder of the soap
pump above the control box groove.
2/10/2020
Control Box
Soap Supply
Soap Tank Vent
C
Position the top of the soap
pump below the control box lever.
Bradley • P20-224 Rev. A: ECO 19-15-015A
Installation
Soap Pump
Vent Tube from
Soap Spout
Assembly
Location of the
Power Source
Connection