Step I:
Step 2:
Step 3:
l;'o configure the Electrohome ECP projector, do this:
Remove System 8/10 top cover (pg. 6-14). See Fig 6-11; locate the projector RS-232
communications board; set switches ancl jumpers as listed in table below.
Note I:
Note 2:
Note 3:
Reinstall System 8/10 top cover.
Configure the System 8/10 switcher as a Primary switcher by setting the address switch
as indicated shown in Fig 6-5, page 6-3.
ELECTROHOME ECP
Extron system switchers only work with Electrohome version 3.1
software and can only switch between RGBS type signals. Do not
use Extron system switchers to switch S-video or composite video
signals, unless you are using a video-to-RGB decorder or a line
doubler along with Video Loop-Back.
Table 6- 7. Comm Board Switch Settings For Electrohome ECP Projectors.
SWITCH/JUMPER
�
' 1·,
.•
SW1
SW2
SW4
SW5
SW6
SW7
SW8
. .. \
- J1
J10
Comm Cable
Page 6-18 • System 8/10 User's Manual
Initial release 3/2/93 switcher PC Ver. 1.5; compatible with
ECP software Ver. 3.1 only.
The projector will only accept RGBS type signals. If you
have composite or S-video inputs you will need a line
doubler or decoder with the VLB feature.
System switchers cannot be looped together when commu
nicating with the ECP projector. The largest number of
inputs is 10.
FUNCTION
Switcher Size
Spare
Unit Number A
Unit Number B
Projector BAUD
Projector Type
Adapter Power
RS-232/422
Comm Loop Back
RS-232/422
SETTINGS
System 8
1 = ON; 2,3,4,5 = OFF
System 10
AI I OFF
1
0
5
3=OFF; 1,2,4=ON
1=ON; 2=OFF
Short1 &2
Short 1 & 2
J 2
I
I
•
• •
• •
• '
• •
• •
• '
I
•
I
I
Ii
i
I
• •
I
' •
I
I
• •
I
• '
t
' '
' '
• •
' •
•