Extron electronics SYSTEM 8 Plus Installation Instructions

Eiki Installation
PROJECTOR COMMUNICATIONS KIT
PLEASE READ THIS DOCUMENT FOR IMPORTANT
THIS KIT HAS BEEN SHIPPED WITH THE FOLLOWING COMPONENTS:
Kit Type: EIKI
Included Communications Adapter(s):
Quantity
1
1
THE TABLE BELOW LISTS THE POSSIBLE CONFIGURATION(S) AND CORRESPONDING
COMMUNICATIONS ADAPTER(S) FOR YOUR PROJECTOR MANUFACTURER'S VARIOUS
MODELS. PLEASE NOTE THAT YOUR SWITCHER HAS BEEN CONFIGURED AS
INDICATED BY THE " " IN THE "Config as" COLUMN. IF YOUR PROJECTOR MODEL
DIFFERS FROM THIS CONFIGURATION, YOU MUST RECONFIGURE YOUR SWITCHER
WITH THE CORRECT SETTINGS.
PLEASE REFER TO THE FOLLOWING PAGES FOR COMPLETE CONFIGURATION AND
SIGNAL CONNECTION INSTRUCTIONS.
THIS SWITCHER HAS BEEN CONFIGURED FOR:
Config Model
as
Eiki LC-X1
Eiki XGA 970
Eiki Powerhouse Two
Extron • System 8/10 P
LUS
SYSTEM 8/10 Plus
ATTENTION!
INSTALLATION INSTRUCTIONS
Part Number
26-467-01
26-474-01
Rotary Switches Cable
RS1 RS2 RS3 RS4 J2/J3 1 2 3 4 5 6 7 8 9 10 Adapter
0 0 F
0 0 F
2 0 F
• User's Manual • P/N 68-403-01 Rev. C
Configuration and Connections
Description
ADP, UNV, "A"
ADP, UNV, "F"
EIKI LC-X1, LC-XGA 970
SW15 Settings
¯ ¯ ­ ¯ ­ ¯ ¯ ¯ ­ ¯ 26-467-01
B J2
¯ ¯ ­ ¯ ­ ¯ ¯ ¯ ­ ¯ 26-474-01
B J2
¯ ¯ ­ ¯ ­ ¯ ¯ ¯ ­ ¯ 26-467-01
B J2
Comm
Page 1