Fein GWP 10 Repair Instructions page 37

GWP 10
7. Fitting
Fitting the handle
1
1. Position the cover (1).
2. Position all electronic components in the handle half shell.
3. Lay all cables.
4. Insert the cable clamping piece (2) and use the screw (3) to screw it in place [0.7
5. Fit the second housing half.
6. Tighten the two screws 9x22 (4) [1.2
7. Tighten the screw 4x30 (5) [1.2
8. Fit the switch pushbutton (6) and use the countersunk screw (7) to fasten it [0.6
C-SC_CSSM Version 1.0
3
2
+0.2
Nm].
+0.2
Nm].
2016-02-02 All rights reserved by FEIN, especially in case of property rights applications.
FEIN retains all rights of disposal, such as copying and circulation
5
4
6
+0.1
Nm].
+0.2
Nm].
.
7
Tools:
- PH1 cross-tip
screwdriver
- PH2 cross-tip
screwdriver
Page 37 of 39