Advertisement
GWP 10
7. Fitting
Fitting the carbon brush holders
1
1. Place the carbon brush holder (1) on the motor housing in the correct position [on both sides].
2. Fasten the carbon brush holders with the two screws (2) [0.6
3. Fit the stranded wires (3) in the motor housing.
4. Connect the stranded wires (4) to the carbon brushes as shown in connection diagram.
C-SC_CSSM
Version 1.0
3
2
3
2016-02-02
All rights reserved by FEIN, especially in case of property rights applications.
FEIN retains all rights of disposal, such as copying and circulation
4
+0.1
Nm].
.
Tools:
- PH2 cross-tip
screwdriver
Page 33 of 39
Advertisement
