Rs-232 And Telnet Commands - Elan Video Over IP User Manual

RS-232 and Telnet Commands

The ELAN Video Over IP system can be controlled via serial and TCP/IP. The following pages list all available serial commands for the
Video Over IP solution.
Commonly used Serial commands:
There are several commands that are commonly used for control and testing:
OUTxxxSTATUS Status will give feedback on Transmitter or Receiver requested
OUTxxxFRyyy (xxx is the Receiver, yyy is the transmitter)
Example: OUT001FR004 (This would switch Receiver 1 to Transmitter/input 4)
Common Mistakes
• Carriage return – Some programs do not require the carriage return where as other will not work unless sent directly after the
string. In the case of some Terminal software, the token <CR> is used to execute a carriage return. Depending on the program you are
using, this token maybe different. Some other examples that other control systems deploy include \r or 0D (in hex)
• Spaces – ELAN commands do not require space between commands unless specified. There may be some programs that require
spacing in order to work.
- How the string should look is as follows OUT001FR002
- How the string may look if spaces are required: OUT{Space}001{Space}FR002
• Baud rate or other serial protocol settings not correct - please see below for Video Over IP settings
ELAN EL-4KPM-VIP-CTRL commands and feedback
COMMAND DESCRIPTION
Firmware version and IP information
Set OUTPUT:xxx From INPUT:yyy (xxx:001~762) (yyy:001~762)
Set TX Audio source to HDMI audio
Set TX Audio source to Analog
Set TX Audio source to Auto
Set Scaler Output Resolution (xxx:001~762)
rr=00: PASS
rr=01: 1080P@50Hz
rr=02: 1080P@60Hz
rr=03: 720P@60Hz
rr=04: 720P@50Hz
rr=05: 1280x1024@60Hz
rr=06: 1024x768@60Hz
rr=07: 1360x768@60Hz
rr=08: 1440x900@60Hz
rr=09: 1680x1050@60Hz
rr=10: 4K@30Hz
rr=11: 4K@24Hz
57
(yyy:001~762)
(yyy:001~762)
(yyy:001~762)
COMMAND
INFO
OUTxxxFRyyy
INyyyAUDORG
INyyyAUDANA
INyyyAUDAUTO
OUTxxxOUTRESrr
EL-4KPM-VIP-CTRL/TX/RX
RESPONSE
FIRMWARE REV: x.x.x
IP ADDRESS: xxx.xxx.xxx.xxx
MAC ADDRESS: xx.xx.xx.xx.xx.xx
Set OUTPUT:xxx From INPUT:yyy
Set Audio source:xxx to HDMI
Set Audio source:xxx to Analog
Set Audio source:xxx to Auto
Set OUTPUT:xxx Resolution rr
www.elanhomesystems.com
USER MANUAL