Table of Contents
Advertisement
Video Over IP Web-GUI - EL-4KPM-VIP-RX - Receiver
The menu structure for the built-in Web-GUI is as follows:
System:
Version Information:
This gives the user an overview of the individual unit you are connected to, including model number and
firmware version
Update Firmware:
Please see page 21 for more information on firmware upgrading your EL-4KPM-VIP-RX Utilities:
Factory Default - resets your receiver unit back to factory settings. The IP address will revert to: 169.254.100.254
Reboot - reboots the receiver unit
Console API Command - please use the EL-4KPM-VIP-CTRL to provide API commands to this unit
Output - this section is the feedback from the API command above - please use the EL-4KPM-VIP-CTRL for feedback
Statistics:
Network - details information about the connection status of the unit you are communicating directly with (unit ID, IP address,
subnet, gateway, MAC address, casting mode (Video Over IP / Unicast), link status and link mode) . Changes to the units IP
address details can only be viewed from this section, please refer to the Network tab to amend the IP structure of the unit.
Video - this is the EDID response from the piece of equipment you are connected to. Not required.
Video Wall:
Basic Set-Up:
Please see page 34 of this manual for the details on video wall set-up
Advanced Set-Up:
This is sub-section is a continuation of the Video Wall section within the ELAN PC Program - please refer to page 35
contact
techsupport@elanhomesystems.com
EL-4KPM-VIP-CTRL/TX/RX
USER MANUAL
46
Advertisement
Table of Contents
