Table of Contents
Advertisement
Regulations
Federal Communications Commission (U.S. only)
The Federal Communications Commission (FCC) has
designated UTAM Inc. to manage the installation and
relocation of Unlicensed Personal Communication Services
(UPCS). This includes Norstar Companion Base Stations and
Portable Telephones.
Companion Base Stations
The radiated and conducted emissions of the Companion Base
Station radios must not exceed the requirements for digital
cordless telephones as outlined in FCC Part 15-subpart D
(DOC RSS-130 documents in Canada). Do not install the Base
Station in ducts, plenums, or hollow spaces used to transport
environmental air.
Note: In Canada, Base Stations may be installed where the
duct, plenum or hollow space is created by a suspended
ceiling having lay-in panels or tiles, in accordance with
CE Handbook Rule 60-402.
Activation (U.S. only)
Wireless communication on a Companion system cannot be
activated until installation at its authorized location is verified
and approved by UTAM Inc. This system is equipped with an
automatic mechanism for disabling wireless operation in the
event it is moved outside the area where its operation has been
approved by UTAM Inc. This mechanism complies with FCC
requirements.
P0941568 01
Modular ICS 5.0 Companion Installer Guide
Advertisement
Table of Contents
Need help?
Do you have a question about the Modular ICS 5.0 Companion and is the answer not in the manual?
Questions and answers
I have a Modular ICS 5.0 with three lines with sips connecting to the Modular ICS. Two lines work but one of the lines only operates with a phone connected to the sip but will not work through the Nortel ICS.
The issue could be that the SIP line is not properly integrated with the Norstar Modular ICS 5.0 system. Possible causes include:
1. The SIP line is not compatible with the ICS system.
2. The ICS is not configured to handle SIP lines.
3. The base station radios are not assigned or activated correctly.
4. The system may not recognize the SIP source if it bypasses the ICS configuration.
Verify that the SIP line is supported and correctly connected through the ICS system, and that the required keys and radio assignments are properly configured.
This answer is automatically generated