Blue Indicator Lights; Gray Indicator Lights - Jeep COMPASS User Manual

130 GETTING TO KNOW YOUR INSTRUMENT PANEL
Speed Warning Indicator Light — If
Equipped
When Set Speed Warning is turned on
and when the set speed is exceeded,
a single chime will sound along with a
pop-up message of "Speed Warning
Exceeded." Speed Warning can be turned on
and off in the instrument cluster display.
The number "55" is only an example of a speed
that can be set.
Speed Alert System Indicator Light — If
Equipped
This indicator light alerts the driver when the
vehicle speed is greater than the specified
limits with an audible waning.
Audible warning frequency:
Speeds above 49 mph (80 km/h) -

1 cycle / 2 minute (primary level)
Speeds above 75 mph (120 km/h)

- 1 cycle / 2 sec (secondary level)
NOTE:
Speed alert system warning signal cannot be
stopped by means other than control of the
speed by the driver.
B I L
LUE NDICATOR IGHTS
High Beam Indicator Light
This indicator light will illuminate to
indicate that the high beam
headlights are on. With the low beams
activated, push the multifunction
lever forward (toward the front of the vehicle) to
turn on the high beams. Pull the multifunction
lever rearward (toward the rear of the vehicle) to
turn off the high beams. If the high beams are
off, pull the lever toward you for a temporary
high beam on, "flash to pass" scenario.
G I L
RAY NDICATOR IGHTS
Cruise Control Ready Indicator Light With
Base Instrument Cluster — If Equipped
This light will turn on when the cruise
control has been turned on, but not
set Ú page 171.
Active Speed Limiter Ready Indicator Light
With A Base Instrument Cluster — If
Equipped
This light will turn on when the Active
Speed Limiter is on, but not set.
Night Vision Suppressed Indicator Light —
If Equipped
This light alerts the driver that the
Night Vision alert status is
Suppressed.