Jeep COMPASS User Manual page 281

280 SAFETY
Suitability of Passenger Seats for i-Size
Child Restraint System Use
The rear outboard seats of the vehicle are
type-approved to house the state-of-the-art
i-Size child restraint systems.
These child restraint systems, built and
type-approved according to the i-Size (ECE
R129) standard, ensure better safety
conditions to carry children on board a vehicle:
The child must be transported rearward

facing until 15 months:
Child restraint system protection is increased

in the event of a side collision:
The use of the ISOFIX system is promoted to

avoid faulty installation of the child restraint
system:
Efficiency in the choice of the child restraint

system, which isn't made according to weight
anymore but according to the child's height,
is increased:
Compatibility between the vehicle seats and

the child restraint systems is better: the i-Size
child restraint systems can be considered as
"Super ISOFIX"; this means that they can be
perfectly fitted in type-approved i-Size seats,
but can also be fitted in ISOFIX (ECE R44)
type-approved seats.
NOTE:
The vehicle seats, i-Size type-approved, are
marked by the symbol shown in Figure XX.
Figure XX
The following table, according to European
standard ECE 129, indicates the possibility of
i-Size child restraint system installation.
i-Size Child Seat Position Table
Front
Device Passen-
ger
i-Size ISO/R2 X
Child
Restraint
ISO/F2 X
Systems
Key of letters used in the table above:
i-U = Suitable for Universal i-Size child

restraint systems, both rearward facing and
forward facing.
X = Seat not suitable for Universal i-Size child

restraint systems.
Rear
Rear
Out-
Center
board
i-U X
i-U X