Jeep COMPASS User Manual page 183

182 STARTING AND OPERATING
this note will disappear. The Surround View
Camera system is comprised of four sequential
cameras located in the front grille, rear liftgate
and side mirrors.
NOTE:
The Surround View Camera system has
programmable settings that may be selected
through the Uconnect system Ú page 200.
Press this button on the touchscreen
to enter the Surround View Camera
menu in the Uconnect system.
When the vehicle is shifted into REVERSE, the
Rear View and Top View is the default view of
the system.
When the vehicle is shifted out of REVERSE
(with camera delay turned on), the camera
image will continue to be displayed for up to 10
seconds unless the vehicle speed exceeds
8 mph (13 km/h), the vehicle is shifted into
PARK or the ignition is placed in the OFF
position. There is a touchscreen button "X" to
disable the display of the camera image.
When the vehicle is shifted out of REVERSE
(with camera delay turned off), the Surround
View Camera mode is exited and the last known
screen appears again.
When enabled, active guidelines are overlaid on
the image to illustrate the width of the vehicle,
including the side view mirrors and its projected
backup path based on the steering wheel
position.
Different colored zones indicate the distance to
the rear of the vehicle.
The following table shows the approximate
distances for each zone:
Distance To The Rear
Zone
Of The Vehicle
Red 0 - 1 ft (0 - 30 cm)
1 ft - 6.5 ft
Yellow
(30 cm - 2 m)
6.5 ft or greater
Green
(2 m or greater)
Modes Of Operation
Manual activation of the Surround View Camera
is selected by pressing the Surround View
Camera soft key located in the Controls menu
within the Uconnect system.
Top View
The Top View will show in the Uconnect system
with Rear View and Front View in a split screen
display. There is integrated ParkSense arcs in
the image at the front and rear of the vehicle.