Ignition Switch; Keyless Enter-N-Go Ignition - If Equipped - Jeep COMPASS User Manual

Hide thumbs Also See for COMPASS:
Table of Contents

Advertisement

attempted to start the engine with an invalid key
fob. Either of these conditions will result in the
engine being shut off after two seconds.
If the Vehicle Security Light turns on during
normal vehicle operation (vehicle running for
longer than 10 seconds), it indicates that there
is a fault in the electronics. Should this occur,
have the vehicle serviced as soon as possible by
an authorized dealer.
CAUTION!
The Sentry Key Immobilizer system is not
compatible with some aftermarket remote
starting systems. Use of these systems may
result in vehicle starting problems and loss of
security protection.
All of the key fobs provided with your new
vehicle have been programmed to the vehicle
electronics.
NOTE:
A key fob that has not been programmed is also
considered an invalid key.

IGNITION SWITCH

K
E
-N-G
I
EYLESS
NTER
O
GNITION
E
QUIPPED
This feature allows the driver to operate the
ignition with the push of a button as long as the
key fob is in the passenger compartment.
The START/STOP ignition button has three
operating modes. The three modes are OFF,
ON/RUN, and START.
GETTING TO KNOW YOUR VEHICLE
— I
F
START/STOP Ignition Button
1 — OFF
2 — ON/RUN
The push button ignition can be placed in the
following modes:
OFF
The engine is stopped.
Some electrical devices (e.g. power locks,
etc.) are still available.
25

Advertisement

Table of Contents
loading

Table of Contents