Power Steering; Stop/Start System - If Equipped - Jeep COMPASS User Manual

ROCK (Trailhawk only): This mode is only

available in 4WD LOW. The device sets the
vehicle to maximize traction and allows the
highest steering capacity for off-road
surfaces. This mode gives you the maximum
performance off-road. Use for low speed
obstacles such as large rocks, deep ruts, etc.
NOTE:
Activate the Hill Descent Control for steep

downhill control Ú page 225.

POWER STEERING

The electric power steering system will provide
increased vehicle response and ease of
maneuverability. The power steering system
adapts to different driving conditions.
WARNING!
Continued operation with reduced assist
could pose a safety risk to yourself and oth-
ers. Service should be obtained as soon as
possible.
If the "SERVICE POWER STEERING" OR "POWER
STEERING ASSIST OFF - SERVICE SYSTEM"
message and a steering wheel icon are
displayed on the instrument cluster display, it
indicates that the vehicle needs to be taken to
the dealer for service. It is likely the vehicle has
lost power steering assistance Ú page 98.
If the "POWER STEERING SYSTEM HOT -
PERFORMANCE MAY BE LIMITED" message and
an icon are displayed on the instrument cluster
display, it indicates that extreme steering
maneuvers may have occurred, which caused
an over temperature condition in the power
steering system. You will lose power steering
assistance momentarily until the over
temperature condition no longer exists. Once
STARTING AND OPERATING
driving conditions are safe, then pull over and
let vehicle idle for a few moments until the light
turns off Ú page 98.
NOTE:
Even if the power steering assistance is no

longer operational, it is still possible to steer
the vehicle. Under these conditions there will
be a substantial increase in steering effort,
especially at low speeds and during parking
maneuvers.
If the condition persists, see an authorized

dealer for service.
STOP/START SYSTEM — IF EQUIPPED
The Stop/Start function is developed to reduce
fuel consumption. The system will stop the
engine automatically during a vehicle stop if the
required conditions are met. Releasing the
brake pedal, clutch pedal or pressing the
accelerator pedal will automatically re-start the
engine.
167