Display And Messages - If Equipped - Jeep COMPASS User Manual

102 GETTING TO KNOW YOUR INSTRUMENT PANEL
To reset the oil change indicator after
performing the scheduled maintenance, refer
to the following procedure:
1. Without pressing the brake pedal, push the
ENGINE START/STOP button and cycle the
ignition to the ON/RUN position (do not
start the engine).
2. Fully press the accelerator pedal, slowly,
three times within ten seconds.
3. Cycle the ignition to the OFF/LOCK position.
NOTE:
If the indicator message illuminates when you
start the vehicle, the oil change indicator
system did not reset. If necessary, repeat this
procedure.
D A M
ISPLAY ND ESSAGES
E
QUIPPED
Includes the following, but not limited to:
Front Seat Belts Unbuckled

Driver Seat Belt Unbuckled

Passenger Seat Belt Unbuckled

Traction Control Off

Washer Fluid Low

Oil Pressure Low

Oil Change Due

Fuel Low

Service Anti-lock Brake System

Service Electronic Throttle Control

Service Power Steering

Cruise Off

Cruise Ready

— I
F
ACC Override

Cruise Set To XXX mph or km/h

Tire Pressure Screen With Low Tire(s)

Service Tire Pressure System

Park Brake Engaged

Brake Fluid Low

Engine Temperature Hot

Lights On

Right Front Turn Signal Light Out

Right Rear Turn Signal Light Out

Left Front Turn Signal Light Out

Left Rear Turn Signal Light Out

Ignition or Accessory On

Vehicle Not In Park

Remote Start Active Push Start Button

Remote Start Canceled Fuel Low

Remote Start Canceled Door Open

Remote Start Canceled Hood Open
