When WinPAC as a master using COM2 communication interface, the pull-high/pull-low resistor
located on the power board must adjust to enable as shown below.
When WinPAC as a master using COM3 communication interface, the pull-high/pull-low resistor
located on the power board must adjust to enable as shown below.
COM3
WP-8000-CE7 Series User Manual, version 1.0.2
Copyright © 2020 ICP DAS Co., Ltd. All Rights Reserved. E-mail: service@icpdas.com
COM2
Master
Slave
Power Board
JP1: Pull-Low Enable
JP2: Pull-High Enable
Page: 159