MX2800 M13 Multiplexer User Manual
If the self test results are...
PASS
BAD RAM DATA
BAD RAM ADDRESS
BAD CODE CHECKSUM
BAD BOOT SECTOR
IOX PROGRAM FAILURE
AFE PROGRAM FAILURE
MODEM FAILURE
ETHERNET FAILURE
DS3 FAILURE
DSX FAILURE
CONFIGURATION CORRUPT
Loading Default Settings
Select
Load Default Settings
settings.
Load Default Settings Other Than System Management
This option defaults all Network and T1/E1 interfaces but does not change management-related options.
Refer to
Management Options
Loading the default settings will set the T1/E1 state of all DS1 ports to
Auto Enable
Load System Management Default Settings
This option defaults all management-related settings but does not default settings for Network and T1/E1
interfaces.
Loading the default settings will set the T1/E1 state of all DS1 ports to
Auto Enable. The User Account Management table is also reset to default.
61200290L1-1G
Table 3-7. Self-Test Results
Then...
The self-test was successful and the unit is ready to use.
Contact ADTRAN Technical Support. For more information, refer to
Appendix F,
Warranty.
Select
Save Configuration
persists, contact ADTRAN Technical Support.
from the Utilities menu. Three options are available for loading default
on page 3-17 for the management-related options.
CAUTION
.
CAUTION
Configuration, Section 3
from the Configuration menu. If the condition
3-39