Table of Contents
Advertisement
Section 2, Installation and Operation
DSX-3 interfaces must be connected using coaxial cables that have the
shields grounded at both ends.
DSX-1/E1 Interfaces
The DSX-1/E1 interfaces are 64-pin amphenol connectors. These interfaces provide Tx and Rx
connections between the unit and equipment such as wire-wrap patch panels, punch-down panels, or
breakout panels.
Connect the DSX-1/E1 interfaces to intra-building wiring only.
Power Connection
The DC power connections are described in
7.
FRONT PANEL
The MX2800 front panel is shown in
•
Craft Port
on page 2-8
•
ACO Buttons
on page 2-15
•
Power Supply A/B Status LEDs
•
Controller Cards Status LEDs
•
T1/E1 Status LEDs
Craft Port
The craft port, an 8-pin modular jack, provides connection to a VT100 EIA-232 compatible interface
(using the supplied 8-pin modular to DB-9 female connector and the 8-pin to 8-pin modular cable).
2-8
Power Up
Figure
2-4. Descriptions of each part of the front panel follow:
on page 2-15
on page 2-15
on page 2-17
Figure 2-4. MX2800 Front Panel
MX2800 M13 Multiplexer User Manual
NOTE
NOTE
on page 2-2.
A
N
A
P
C
E
L
R
T
T
M
F
61200290L1-1G
- Quick Links:
- Establishing Terminal Connection
Hide quick links:
Advertisement
Table of Contents
