Network Interface; Ds3 Configuration; Framing; Line Length - ADTRAN MX2800 M13 User Manual

Section 3, Configuration
2.

NETWORK INTERFACE

Select
Network Interface
MX2800 network settings to match the DS3 signal received from the service provider.

DS3 Configuration

The DS3 Configuration selections are used to configure the DS3 network settings to match the desired
application. Descriptions of these settings are explained below.

Framing

The framing format is used to match the format of the receive signal at the network interface. The MX2800
supports C-bit and M13 framing formats.
M13 may not be selected when IP Forwarding is active.

Line Length

The line length is set to reflect the physical length of the DS3 network line.
• Long should be used if the cabling distance exceeds 225 feet.
• Short should be used if the distance is less than 225 feet.
3-4
to access the network configuration parameters. See

Figure 3-3. Network Configuration Menu

MX2800 M13 Multiplexer User Manual
NOTE
Figure 3-3. Configure the
61200290L1-1G