ADTRAN MX2800 M13 User Manual page 81

MX2800 M13 Multiplexer User Manual
The standby card must remain in place until the upload process is
complete and the
flashing green. Removing the standby card during the uploading process
will corrupt the software.
7. The system must be manually reset after downloading new software for the active controller card to
begin running the new code. From the Utilities menu, select
to immediately reset the system or
Immediate Reset
to reset. Once the system has been reset, the new software will be running.
This function is available only when updating the software through the
craft port.
Update Via TFTP Server
Updating the FLASH Software via TFTP Server requires that the IP address and file name of file to be
downloaded be known. To update the software via TFTP, follow the steps below:
1. Select
Update via TFTP Server
and file name of the file to be downloaded to the unit to be entered. Once this information is entered,
select
Start/Stop Transfer
2. After the binary file is selected, the TFTP transfer will begin. To cancel a transfer in progress, press
three times. The
C +X
TRL
The LED on the standby card is blinking green.
ACT
3. If updating a unit with redundant controller cards, the active controller begins uploading the new code
to the standby controller after the XModem transfer has completed; and the unit has successfully
loaded and programmed the new software into its FLASH memory. If the unit does not have redundant
controller cards, go to
4. While the standby card is having code uploaded, the
amber. After the code has finished uploading to the standby card, the card will reset itself and begin
running the new code.
The standby card must remain in place until the upload process is
complete, and the
standby card during the uploading process will corrupt the software.
5. The system must be manually reset after downloading new software for the active controller card to
begin running the new code. From the Utilities menu, select
61200290L1-1G
CAUTION
LED is no longer solid amber and returns to
ACT
NOTE
from the Utilities menu. A new menu displays, allowing the IP address
.
LED on the active card is solid amber for the duration of TFTP transfer.
ACT
Step 5.
CAUTION
LED is no longer solid amber. Removing the
ACT
, then select either
System Reset
to set a time for the system
Schedule Reset Time
LED on the standby card will be solid
ACT
. Then select either
System Reset
Configuration, Section 3
3-41