Load Default Settings; Update Flash Software; Update Via Xmodem - ADTRAN 1200287L1 User Manual

Chapter 3. Configuration

Load Default Settings

Select
screen will display
traffic on all ports.
The IP Address, Default Gateway, and subnet mask will not be reset
when default settings are loaded.

Update FLASH Software

Select
software using either XMODEM protocol or Trivial File Transfer
Protocol (TFTP).

Update Via XMODEM

Select
menu; then select
1-S
terminal menu program (the XMODEM utility is available under
most terminal programs). If you wish to cancel a transfer in
progress, press
This function is available only when updating the software through the
CRAFT
3-40
Loading the default settings will disable all STS-1 ports.
L D S
OAD EFAULT
!WARNING! Defaulting configuration will disrupt
Select
U F S
PDATE LASH
U XMODEM
PDATE VIA
1-S
TART
from this menu, start the XMODEM transfer from your
TART
- three times.
Ctrl X
port.
MX2800 STS-1 User Manual
from the
U
ETTINGS TILITIES
C to proceed or press
ONFIRM
from the
U
OFTWARE
from the
U
PDATE
to begin the transfer. Once you select
menu. The
to abort.
Esc
menu to update
TILITIES
FLASH S
OFTWARE
61200659L1-1