Tl1 Autonomous Messages - ADTRAN MX2800 M13 User Manual

MX2800 M13 Multiplexer User Manual
SET-DAT:<tid>::<ctag>::<YY-MM-DD>,<HH-MM-SS>;
Description
PARAM1
PARAM2
* An asterisk indicates optional command blocks.

TL1 Autonomous Messages

Autonomous messages provide a mechanism for real time reporting of system events. Although most
events reported are alarms, some events are only informational. The Verb, Mod1, and Mod2 parameters of
the message indicate what type of event has occurred.
The default setting for Autonomous message reporting is
Follow these steps to enable Autonomous message reporting:
• If it has not already been done, initiate a TL1 session by following the setup procedures and using the
command.
ACT-USER
• Use the ALW-MSG command to enable autonomous messaging. This command is described in
Table 9-2 on page 9-6.
REPT-ALM indicates an alarm event.
alarm events and includes recommended actions to take. REPT-EVT indicates an informational event.
Table 9-4 on page 9-16 lists possible autonomous messages for informational events
61200290L1-1G
Table 9-2. TL1 Commands (Continued)
Sets the date and time
Date in YY-MM-DD format
Time in HH-MM-SS format
NOTE
Table 9-3 on page 9-12 lists possible autonomous messages for
Transaction Language 1 (TL1), Section 9
.
OFF
9-11