EU: For a quick check of the correct direction of the front light beam, place the vehicle
ten metres from a vertical wall and make sure the ground is level. Turn on the low-
beam light, sit on the vehicle and check that the light beam projected to the wall is a
little below the headlight horizontal straight line (about 9/10 of the total height).
In order to carry out vertical adjustment of the light beam:
•
Rest the vehicle on its stand.
•
Working from the left rear side of the front headlight, use a short crosshead
screwdriver on the specific screw (1). SCREW it (clockwise) to raise the light
beams; UNDO the screw (anticlockwise) to lower the light beam.
04_38
NOTE
CHECK THAT THE LIGHT BEAM VERTICAL DIRECTION IS CORRECT.
Front direction indicators (04_39)
•
Rest the vehicle on its stand.
•
Loosen and remove screw (1).
•
Remove glass (2).
•
Press bulb (3) slightly and turn it anticlockwise.
•
Pull the bulb (3) out of its fitting.
•
Insert a bulb of the same type adequately.
WARNING
IF PARABOLE (4) STICKS OUT OF ITS FITTING, INSERT IT AGAIN PROPERLY.
04_39
Rear optical unit
This vehicle has a LED rear headlamp; have it replaced at an official aprilia Dealer.
105